When cutting machines cut paper, there will be a series of situations such as paper that is not cut off. Do not panic when there are situations. Observe the problem carefully and find the corresponding solution. Re -roll paper manufacturers introduce you to the abnormal operation when the re -roll machine cut paper cutting paper is abnormal. Solution.
1. Two paper rolls under the re -roll machine are connected together. The paper pages are not cut into small faults. If this kind of problem occurs, first check whether the paper cutter blade is intact. If it is intact, check the paper cutter knife After the knife is put on the bottom knife, first move the paper knife to the position without a bottom knife when checking, and then check it on the knife. If the blade is not attached to the action after the knife is put on, remove the small cover of the back of the paper knife. Replace the blade of the knife.
2. When the rising paper rising process is not in place, check whether the limitation of the instrument is normal, and then check the paper -cutting knife tooth box. Too many chains are stretched, causing inconsistent rising sides. If the chain is too long, take a section.
3. When the rolling machine is rising, when the knife rack is posted by a roller, check whether the two sides of the paper knife are working properly during the rise. At this time, you need to replace the cylinder; if there is no failure of the cylinder, then adjust the fixed bolt of the blade rack. When adjusting, it should be under the re -roll machine to make the paper knife run normally.
4. When the rolling machine cuts the knife and knife, the hand is manually rotated and the jump is greater, remove the cutting knife header and replace the round knife shaft
