Feeding, film piercing and splicing operation of slitting machine

1. Loading operation:
According to the requirements of the slitting plan sheet, in accordance with the driving operation rules, and according to the actual situation, the corresponding parent roll is hoisted on the aging rack, placed on the unwinding rack of the slitter according to the direction selected from the inside and outside of the corona surface, and the steel roll is clamped with the control button. Core, leave the steel core support arm and drive.
2. Membrane penetration operation:
When there is no film on the slitter, the film must be threaded. The user can use the film threading device and function keys of the slitting machine to tie one end of the original film to the eye of the film threading chain, and activate the film threading button to make the film evenly distributed on each roller along the slitting process.
3. Film connection operation:
When there is a film on the slitting machine, when changing the roll joint, use the vacuum film splicing table to first start the film splicing table to the working position, manually flatten the film on the first traction roller of the slitting machine and start the upper vacuum pump to suck the film, so that The film is smoothly adsorbed on the splicing table, affix the double-sided tape and cut off the excess film under the tape, flatten the film on the unwinding frame and start the lower vacuum pump to make the film absorb smoothly, take off the upper paper layer of the tape and Flatten the adhesive film, the joints should be neat and wrinkle-free, then turn off the upper and lower vacuum pumps, and open the film splicing table to the non-working position.